-
Power Requirement:AC 110-120V/220-240V
● Carrier Frequency Range:230 to 260 MHz, VHF high band.
● Frequency stability:±0.005% with quartz controlled.
● Modulation Mode:FM
● Maximum Deviation Range:±25KHz, with limiting compressor.
● Frequency Response:40 Hz to 20 KHz.
● S/N Ratio:Better than 80 dB.
● T.H.D.:Less than 0.5%.
● Audio Dynamic Range:Over 90 dB.
● Service Areas:50meters.
● Temperature Range:-10℃to 55℃
-
SPECIFICATIONS:
Frequency Range: 730~950MHz
Selectable Channels: 2×16
Oscillation Mode: PLL synthesized
Audio Output: Balanced XLR Unbalanced 1/4″jack socket
Modulation Mode:FM
Battery Requirement: 2×1.5V AA size
-
Description: UB 210, UHF
19 inches standard receiver and transmitter
More channels are used at the same time without rejection
Fit out handle microphone or clip microphone
The UB-210 accommodates dual channels and quartz-controlled
frequency receiver tuner
LED indicators display RF/AF signal on the fron panel
The rear panel consists of antenna connectors,MIC/LINE selective
switch,unbalanced phone jack,balanced XLR output connector
and a DC power input connector.
Advanced PCB layout results high sensitivity and extreme low
spurious emissions
Dual "pilot & noise lock" prevents the system from unwanted signals
and random noise interference.
-
Headset microphone
for models: LS-202; PLL-253
Element: Back Eleclret Condernser
Polar Pattern: Uni-Directional
Frequency: 70Hz-16KHzPrice: 48 BGN
-
K series dynamic microphone adopt the
newest dynamic cartridge, it has the
advantages of dynamic & condenser
microphone, and be suited for high-standard
singing,loudening,recording and receiving
sound signals.
Element: Moving Coil Dynamic
Polar Pattern: Uni-Directional
Frequency: 50Hz-16KHz
Sensitivity: -72dB±3dB(1V/Pa)
Output Impedance: 380Ω±30%(at 1 KHz)
Material: Zine die-cast
Net Weight: 300g(without cable)
-
Key Specifications/Special Features:
Microphone type: dynamic
Polar pattern: super cardioid
Frequency response: 50Hz to 18kHz
Impedance: 300 ohms +/- 30%
Sensitivity: -73dB +/-3dB at 1,000Hz
Dimensions: 51 x 100mm
Weight (without cable): 300g
Primary Competitive Advantages:
Product Performance
Prompt Delivery
Quality Approvals
ISO 9002 Quality Approval
-
Type Electret condenser
Polar pattern Cardioid
Frequency response
BD-940 50~18KHz
BD-940 130dB(at 1KHz≤1%T.H.D)
BD-940 -45dB±3dB(0dB=1V/Pa at 1KHz)
Length 460mm
Output Connector integral 3-pin XLRM-typedioid
Frequency response
BD-940: 50~18KHz
Max input SPL
Electret condenser
Polar pattern Cardioid
Frequency response
BD-940 :50~18KHz
BD-940:-45dB±3dB(0dB=1V/Pa at 1KHz)
Length BD-940 460mm
Output Connector Integral 3-pin XLRM-type
BD-940 -45dB±3dB(0dB=1V/Pa at 1KHz)
Switch 50~150Hz Roll-off -10dB
-
Uni-directional reflexible Condenser Microphone
Element:condenser
Pollar Pattern:Uni-directional
Frequency Response:50Hz 15KHz
Dynamic Range(typical):100dB,1KHz at Max SPL
Sensitivity:-43dB(7.0mV),1V at 1 Pa
Input impedance:200 ohms
Output connector;
XLR(male), for the power supply module
Phantom power:15 52V,2m A
Accessory with:power supply module,microphone bag
Weight:120g
-
Condenser Boundary Microphones
Uni-directional reflexible Condenser Microphone
Technical Specifications
Polar Pattern Unidirectional
Frequency Response 50Hz~15KHz
Sensitivity -53dB±3dB(0dB=1V/Pa at 1KHz)
Output Impedance 200W
S/N Ratio 60dB SPL.1KHz at Pa